Copyright & Safety Information
Copyright to all material on this disk is held by Jon Eakes Enterprises Inc. Without prior written consent, copying or reproduction in whole or in part of this video and written material by any means is prohibited. Any such action renders the offender liable to prosecution. These videos do not demonstrate or explain all necessary codes and safety procedures. Consult your local building office for code specifications and your Federal, Provincial and State Departments of Health and Safety for safety guidelines before proceeding with work.
Attaching To Wood Framing
Where do you start installing drywall -- the wall or the ceiling? How do you hold up the ceiling panels, or shift wall panels up? What fasteners should be used and what tools are best for working with wood studs? How do you find the studs after you cover them? How do you cut out electrical boxes and get the hole in the right place? Fiberglas insulation requires some special techniques and you must plan drywall placement according to corner trim that will be used.
Related Topics: Drywall, Fasteners, Installation, Instructions, Nails, Screws, Studs, Techniques, Tip, Tools, Walls
Send To A Friend
Learning Curve 14
Showing 4 comments
Viewing from newest to oldest – Reverse
Subscribe by RSS
Subscribe by Email
had a 1200 square foot house plasered. plasterer started on a thursday and finished on a sunday. this included primer and two finished coats of paint for the ceiling. on sunday the plaster said their are cracks appearing on the ceiling and in the walls running along the seams of drywall.of course the plasterer said it wasn't his fault. tell me what you think happened.
Fewer joints when hung horizontally if using 10 or 12 foot sheets, also your joints are at a nice working level for filling and sanding if horizontal . Only 4 feet for knowing where the studs are as opposed to 8 feet when installed vertically. Course thread screws for wood .
On a ceiling it is always best to start screws in the centre of the 8 feet to take up any sag ,and work toward the ends from the center. there will almost always be a little sag and if the ends are scewed first the sheet will not pull up .
Thane, you can see my answer to that in video if you look to the left of this page and click on "Panel Layout Patterns". Both techniques work and although pros almost always put them on horizontally there are good reasons for someone inexperienced, especially in making wide butt joints, to put it on vertically. You get all "valley" joints. Jon
Every house that I have every seen dry wall in they hang in horizontally, but resently on canada's worst handyman I believe that the host mentioned that it should be hung vertically. What are your thoughts on this.